Best Tube Light Choke Connection

Due to the sudden change of supply the chock will generate around 1000volts.

Tube light choke connection. The filaments light up and instantly warm up the tube. Electrical choke is nothing but an inductor which is connected in series with vapor lights. When an ac voltage is applied to a tube light fixture the voltage passes through the choke the starter and the filaments of the tube.

Connect the other terminal of ballast to terminal of first tube light then connect tube light 2 with first one serially as show in the illustration. The ballast employed to convert the ac supply frequency to high frequency and the ballast regulates the supply given to the tube light. Once the current passes through the tube the starter circuit will be out of part.

Find more details https goo gl 62f9py circuit schematics and the source code here. Here two tube lights are used in our case each one is 20 watts each tube light will have two filament with four terminals connect starter element to any on side of tube light after that link phase line to the ballast choke through switch. Electronic ballast choke tube light wiring is simple as normal tube light or it is even simple.

The starter is made up of a discharbe bulb with two electrodes next to it. When an ac voltage is applied to a tube light fixture the voltage passes through the choke the starter and the filament of the tube. This creates light however the heat from the bulb causes.

Finally bring neutral terminal from tube light 2. The filament light up and instantly warm up the tube the starter is made up of a discharge bulb with two electrodes next to it when electricity passes through it. I have shown tube light connection without starter i.

Now there is no change of supply causes choke voltage normalized and act as. Check my new video https youtu be eqnenms wrk share this video. Thanks for watching like share comments subscribe.