Smart Replacing A Dimmer Switch With A Standard Switch

The dimmer switch has a black white wire and ground.

Replacing a dimmer switch with a standard switch. Can someone kindly give me directions with the following options please. The dimmer switch is now installed and ready to go. Loosen the screw that holds the grounding wire to the switch and remove the dimmer switch from the switch box.

Be sure to turn the power back on and test it out to make sure it fully works. Richard from the information you have provided yes when replacing a standard dimmer switch with a single switch simply install the single switch and connect the wires to the switch terminals. Use your flat head screwdriver and screw the faceplate in with the two included screws.

Secure it by tightening the screw then attach the traveler and or common wires from the switch box to the screws at the sides of the new switch in the same manner. How to change a dimmer switch to a normal switch warning. If you have any doubts in any step contact a.

Turn off the power to the switch at the circuit or fuse panel. A blue a brown b blue b brown c brown c black c grey. Then use a voltage tester to make sure that the circuit is dead.

Place one black wire on one screw and the other on the other screw after you have disconnected the power. Unscrew and remove the switch plate. Next using a pair of needle nose pliers wrap the bare ground wire around the green screw at the bottom of the new standard switch.

Just buy a single pole single throw switch to replace the dimmer switch. I have been trying to replace a double dimmer switch with a double standard switch but not having any luck. Take extreme caution while working with electricity.